Standard Frame (9mm, .40, .357) Glock Gen 3 MRCK (Mag Release Conversion Kit)

Standard Frame (9mm, .40, .357) Glock Gen 3 MRCK (Mag Release Conversion Kit)This will only work in the standard width frame Glock models (9mm, . 40, . 357) and WILL NOT work in the wide frame models (. 45 acp, 10mm) The MRCK (Mag Release Conversion Kit) converts your Glock gen 3 pistol's magazine release button to the same ergonomics as a gen 4 5. The only thing required to install the kit is a drill and a few minutes. Manufactured on MKM's MJF machines from a high quality PA11 Polymer. *This will NOT allow ambidextrous use

or GLOCK Ges

This will only work in the standard width frame Glock models (9mm

or components

Manufactured on MKM's MJF machines from a high quality PA11 Polymer

45acp/10mm and WILL NOT work in the standard frame models (9mm

and is one of many trademarks owned by GLOCK

357) and WILL NOT work in the wide frame models (

or those of you brave enough to try to cut the hole yourself

"GLOCK" is a federally registered trademark of GLOCK

THIS DOES REQUIRE YOU TO DRILL/CUT YOUR FRAME AND IS A PERMANENT MOD

Made in the USA

The MRCK (Mag Release Conversion Kit) converts your Glock gen 3 pistol's magazine release button to the same ergonomics as a gen 4/5