CAN Resistor for BUDS Activation

CAN Resistor for BUDS ActivationSame as 529036355 Can't get BUDS to connect to a first gen SkiDoo Rev carb engine with an ECM, or an SDI? If you can connect to SkiDoo XP chassis ECMs but not a first gen Rev chassis ECM, this is what you're missing. The resistor plugs into your MPI3 interface. Needed for the following according to BUDS chart V 1000, V 810, and SDI models (except XP 600SDI) SeaDoo 4 Tec with I Control Carbed models with ECM printed on electronics box (except XP models)

518325114 - 518325115

375" flange

regular squeeze style rivet tool won't pull these

Sick of dealing with the DESS key not reading properly

greasing the bearing/s will be required on a somewhat regular basis

Resistant to water washout and chemical degradation

contents stay in compartments and don't spill out

full gasket set with oil seals

06" max head height

it plugs into that connector

and under the hood in the fuse box on the SDI models

Fits Soldering Iron (2488-20)