Bando P30-8M-30 HT QD Timing Belt Pulley (D) PLATEBando P30 8M 30 The type of pulley used on a Synchro Link drive depends on a number of factors, including but not limited to, space available, ratios, center distances, horsepower being transmitted, speeds and user preference of mounting systems (i. e. QD, TL or Minimum Plain Bore). With Synchro Link Drives, as with gear or chain drives, circular pitch (usually referred to as pitch) is a fundamental consideration. On the belt, pitch is the distance
375 IN Shaft Ground Indicator No Shaft Grounding Shaft Rotation Reversible Shaft Slinger Indicator No Slinger Speed 1185 rpm Speed Code Single Speed Motor Standards NEMA Starting Method Wye Start - Delta Run Thermal Device - Bearing None Thermal Device - Winding None Drawings
Bando - RPF6555 Molded notch design gives extra flexibility to reduce heat build-up and provide long belt life
Suction = Air Through Fan and Over Motor
6 RPM 1760 FRAME 284U SER
33 HP - OPEN - 1650 PHASETYPE 1_PERMANENT SPLIT CA MOTOR ENCLOSURE OPEN HORSEPOWER
Series EXWX-M Panel type Across the line Horsepower (HP) 20 HP Enclosure type Wall mount Thermal Managment None General enclosure options None Main voltage 575 V Control Voltage Not applicable Frequency 60 Hz SCCR rating 25 kAIC Disconnect switch type Circuit Breaker rotary handle disconnect Bypass type None Control power transformer No transformer required Reactor/Filter None Communication None Control options None Enclosure rating Type 7/9 Nominal height 285
Amperes 175-159/79
33 FULL LOAD AMPS PRIMARY 14
Break-Down Torque 7
Nominal Outside Length (mm)3200
67 % Rated voltage 400 V Rated current 530 A L
Bando - 10B95 To resolve problem applications where belts are flipping over or jumping out of the sheaves
