Carbon fiber tubes for MNT40 FAI Tower Launcher Size:50 cm

Carbon fiber tubes for MNT40 FAI Tower Launcher Size:50 cmIt includes three 12 mm carbon fiber tubes (500 mm long or 1000 mm long). This is an accessory item to MNT40 FAI Tower Launcher

Design by Brian Muzek

Set of four laser cut 1/8" plywood fins and three laser cut 1/8" plywood centering rings to replace the balsa fins and cardboard centering rings featured in the kit

The 3D printed parts are printed using resin material and a SLA printer

The fiberglass tubes ARE NOT included

This kit is an entry-level kit to allow you to compete in parachute

4 adhesive mylar strips

Blades are laser cut from 1/16" balsa and will need to be formed and attached to the hubs

It includes three 12 mm carbon fiber tubes (500 mm long or 1000 mm long)

In order to launch the SK 369 you will need a tower launcher

whose model you see in the photo

Applying a primer is needed before final painting

It also provides for an offset of the fins from the end of the body tube to allow for motors to be taped to the tube