Universal B2 & C2 Take-up Bearing Assembly B3

Universal B2 & C2 Take-up Bearing Assembly B3This is for the Universal B2 & C2 models. The bore of the bearing is 7 8. It is used on the boot to take the slack out of the belt.

If buying this brush for a number 8 series cleaner

or 68D require you to cut 1 brush into two pieces and install them on the smaller H frame carrier under the scalper screen

F924 31040

If it is used on the clipper hoppers it is not necessary to grease the bearings because the original bearings on clipper hopper were not greaseable

Eliminator 224 & Clipper M-2B idler shaft bearings with pillow block housing

5/8” diameter X 6

This Support bracket is for the Eliminator 224 Auger

7 series (any clipper seed cleaner with the model number ending in 7 takes 39 5/8” long wood tracks)

This listing is for the support bracket only

Numerous Models Available - see the drop down box for models

Choose RIGHT or LEFT in the drop box box

This is for units with 1 ½” shafts and 9” diameter thrust discs