7'0" Tanner Hull body7'0" x 22 1 4" x 2 3 8" Shaped by Tanner Prairie of Costa Mesa, this board is a nod to the displacement hulls of the late 1960s. The outline is very similar to the displacement sleds of that era, with a full round nose and pulled in rounded pin tail. The rails are also true to the classic foil of displacement hulls; they are super bladey, creating speedy and connected rail engagement for down the line surfing. The bottom is fully bellied, of course,
With the narrower nose you'll find it easier to lay your Liddle on rail and wrap turns with more fluidity
The bottom contours are strictly convex with a gentle roll throughout the length of the board
rough shipping estimates to some countries can by reaching out to hello@daydreamsurfshop
fishes and everything in between
that is direct design influence from Lynch
Robin Kegel of Gato Heroi is the genius board builder that developed what we consider to be the king pin of high-speed logs
*Center Fin Not Included
We see this sort of as our replacement for a thruster as it works in many conditions comparable to what we would normally choose to ride a thruster in
like this Hanel
This elongates the apex of the double concave's spine into a bell shaped curve that introduces properties of convexity to a bottom contour that has traditionally been mostly focused on its concave structure
The classic outline has the wide point set slightly back from center with a slightly pulled in nose and moderate tail width
*DISCLAIMER: used boards are well-loved and may have pressure dents
