5'10" Andreini Bullet surfgear

5'10" Andreini Bullet surfgearMarc Andreini needs no introduction, he's one of the most renowned surfboards builders living today. His Bullet model is his lower volume shreddy single fin with side bites. The outline is full with a plump nose and tail while the bottom contours start with a light roll in the nose that quickly transitions into a single concave and into a double concave out the tail. The rails are boxy and full with a sharp, shortboard like trailing edge starting by

The baseline tail rocker is set at 1

the Spiral Hull is shaped from an EPS blank and reinforced with carbon fiber strips on the deck that are hidden by white pigmented volan cloth on the deck with a raw lap finish on the bottom

The outline of the Fluer exhibits a centered wide point with a blunt full nose juxtaposed by a pulled in pin tail

this model is pretty medium in just about every way with a light rolled bottom that fades into a vee out the tail

moisten and bedew

The outline of the Alpha Omega was largely inspired by Mark Richards (MR) who was arguably the heaviest hitter in the twin fin world at the time

Gato Heroi made limited edition wetsuits with tastefully low key black logos on these beautiful

Removes makeup

sweeping turns that leverage the boards length through its swing weight allowing the rider to draw fish-style lines in a really graceful fashion

Realizing that the traditional fish model can be limiting in less reliable punchy surf

this "Malibu Chip" influenced pig known as Tanner's Dash model is a period correct reflection of surfing's fun-loving era where boards trimmed fast and brief nose rides were accomplished with speed and agility

The film photographs collected here