B7 - 73mm Arm Wide Pivot C and D Block Set Accessories

B7 - 73mm Arm Wide Pivot C and D Block Set AccessoriesB7 73mm Arm Wide Pivot C and D Block Set! That's right, a wide pivot set to be used with the 73mm Wishbone from the B6 series. This increases the pivot width +5mm each side (10mm total) and MUST be used in conjunction with the AE #91853 or #91873 73mm Rear Suspension arms. When used in conjunction with AE #91853 or #91873 73mm Rear Suspension arms this retains the original kit B7 position of the OUTSIDE (Hub) Hinge Pin. This leaves the track width

Clear anodised finish featuring Willspeed logo

Includes replacement hardware

Manufactured in 7075 Aluminium incorporating +2mm and -2mm link positions

This product includes both C and D Blocks and must be used as a pair

B7 - Aluminium +4 +0 Caster Block Link Mounts

5 Degree Increments

Manufactured in 7075 Aluminium with a clear anodised finish

Redesigned to take 5 X 9 X 3mm Bearings (Supplied) Reducing the bearing diameter to increase the material section at the root of the gear tooth to improve strength and durability

We wanted to create the ultimate fit and forget Idler Gear solution for the Team Associated B7 in terms of performance and reliability

Carbon Fibre Roll 0

Replacement Idler Pins for the Willspeed RF3 Conversions

Manufactured in 7075 Aluminium for increased strength over standard plastic item yet significantly lighter than our stainless steel offerings